Over the last few years, more and more people have been becoming aware of the anti- cancer benefits of cannabis.
There are numerous studies that have shown the ability of this plant to fight tumors.
Even the use of radiation and the chemotherapy are approved to treat cancer by the medical fraternity, it is very important for the people to be informed about other natural alternatives.
This plant is used by thousands of people for treating cancer. There are cases where a nine-year old cured her cancer by cannabis and also an example where cannabis oil is dissolving a cancerous tumor in eight-month old baby.
R. Simpson has treated more than five thousand patients, all free of charge. He believes that every condition and disease is treatable and that it’s common to have every type of disease and cancer cured by using hemp oil (high quality) as a treatment.
You can watch his documentary ‘’Run from the cure’’, if you want to learn more about him.
His documentary is consisted of interviews with individuals cured by the Rick’s oil, but refused from testifying on his behalf in the Canada’s Supreme Court in his 2007 trial. This documentary explains the hash oil’s medicinal benefits.
He is a proponent of the medical marijuana. Rick is also a cancer survivor and he had cured his metastatic skin cancer with cannabis oil, a decade (or more) ago.
To make his cannabis oil recipe, you should start with 1 oz. of dried herb. This dosage will produce three to four grams of oil, but the amount of oil will vary strain to strain. One pound of dried material will give 2 oz. of high quality oil.
It is important to know that these instructions are summarized from the website of Rick Simpson. You should be very careful when you boil the solvent off because the flames are extremely flammable. You should also avoid red hot heating elements, stove- tops, sparks and smoking. Place a fan in order to blow the fumes away from the pot and set up in an area that is well- ventilated for the whole process.
-Set up the dry material in one plastic bucket.
-Use the solvent to dampen the material. You can use many solvent but there is also a solvent- free option. You can use even water, 99 percent isopropyl alcohol, butane, ether or pure naphthta. It is needed 2 gallons of the solvent to extract THC from 1 pound, and 500 milliliters is enough for 1 oz.
-Use clean and untreated wood (or some other similar device) to crush the plant material. It will be relatively easy to crush it as the plant is dry.
-Continue to crush the material and in the same time add the solvent until the material is completely soaked and covered. Stir the mixture for about 3 minutes and the THC is dissolved the material off in to the solvent.
-Pour the mixture oil off the plant material in other bucket. That is how you’ve stripped the material of about eighty percent of its THC.
-2nd wash: add solvent to the mixture and stir for another 3 minutes in order to extract the THC that has remained.
-Pour it in the bucket in the previously poured mixture.
-You should discard the plant material that was twice washed.
-Then, pour the oil mixture through a coffee filter in a clean container.
-After that, boil the solvent off in a rice cooker and it will nicely be boiled and will hold over ½ gallon of the solvent mixture. Be careful and avoid open flames (the fumes are very flammable), cigarettes, sparks, red hot element and stove-tops.
-Pour the solvent into the rice cooker so it’s about ¾ full. Turn it on high heat. You should be in an area that is well- ventilated and place a fan in order to carry away the solvent fumes. Add the mixture to the rice cooker as the solvent is evaporating until it is all added in to the cooker.
-As the rice cooker’s level is decreasing for the last time, you should add about ten drops of water per one pound of dry material. This helps to protect the oil from too much heat and to release the solvent residue.
-When in the rice cooker is about 1 inch of the mixture, put oven mitts and pick up the unit. Then, swirl the contents until it has finished boiling off.
-After that, turn the rice cooker to low heat and at no point the oil should reach over 1400 C or 2900 F.
-You should keep on the oven mitts and remove the pot that contains the oil from the cooker and gently pour it in a steel (stainless) container.
-Then, place the container in a dehydrator or on a heating device (coffee warmer). The water and the volatile terpenes are going to be evaporated from the oil even it may take few hours. It is ready for use when there is no surface activity on the oil.
-Suck up the oil in a plastic syringe or in some other container that you see fit but the syringe will make the oil really easy to dispense. When it is completely cooled off it’ll have a thick grease consistency.
You should do a research before you do something to make sure that you understand how this thing works and you should consult a physician.
This is a video for you to see how this process looks like:
Get more stuff like this
in your inbox
Subscribe to our mailing list and get interesting stuff and updates to your email inbox.
Thank you for subscribing.
Something went wrong.